Throttle by wire is a technology that makes connections or systems on the pedal towards the throttle without sling cable, but rather using sensors, connected on a computer or Electronic Control

The throttle plate shaft is connected to a small motor and spring that responds to inputs from the computer. At idle, the computer commands the throttle plate to crack open slightly, much like the old carburetors. This feature eliminates the need for an idle air bypass valve. When the engine is off, the throttle plate is fully closed.

114 posts · Joined 2001. #17 · Feb 5, 2006. Thanks for all the help. The car is for street and nostalgia drags (80" wheelbase). I will check out neal brakes. The drive by wire idea sounds too risky for a home job. I'll post the results on my project page, but right now I'm trying to sort out the front disc brakes.
On some vehicles you will need to perform a relearn after cleaning. Otherwise your idle speed will not be correct. Honda’s and Nissan come to mind. On some throttle bodies if you use a toothbrush, you will remove too much from the throttle body and the throttle plate will not sit correctly after cleaning, and you won’t be able to perform
The first step in removing the throttle is removing the pins from the connector and pulling the wire out of the handlebar. This picture shows the wires entering the bars at the clamp. With a small screw driver or pick, carefully pry the assembly out of the bar. Slide the assembly out. 5.
The drive-by-wire is proactive, while the drive-by cable is a reactive system. In the DWB system, the throttle is activated by pressing on the pedal, which sends a signal to the sensor that interprets it with the help of a computer. However, in the DWC system, after pressing the pedal, the throttle cable manually controls the inlet and outlet 2820 posts · Joined 2009. #1 · Jan 27, 2010. What is the general feelings regarding the fly by wire (or whatever its called) throttle that Harley has changed to. I don't have it and I don't like the sound of it. Hearing stories with folks having problems changing handle bars and functional glitches in general. Solution: The solution is simple. Use the flat-headed screwdriver to open up the throttle compartment and clean up the mess inside. If it’s because of the dust and debris, you may want to use a blow dryer and simply blow the dust away. For tangled wire, your fingers can do what is necessary. 2. The LS1 Corvette throttle body was the first electronic throttle body used with Chevrolet V engines. The throttle position sensor is mounted on the bank 2 side of the engine and the throttle shaft motor is mounted on the bank 1 side of the engine. The blade on this throttle body measures approximately 75 mm in diameter.
Fly by Wire: What it Means “Fly by wire” is a phrase used to describe a system on an airplane that uses computers rather than mechanics to process flight controls. The computer works by sending signals to an actuator, which then determines how control surfaces are moved to satisfy what the pilot tells it to do via a sidestick or yoke.
Step 7. Locate the throttle wire. Disconnect the throttle wire plug from the controller wire plug. Take caution while handling these wires. You can easily damage them. Add a comment.
.
  • 087ql0af45.pages.dev/654
  • 087ql0af45.pages.dev/343
  • 087ql0af45.pages.dev/603
  • 087ql0af45.pages.dev/450
  • 087ql0af45.pages.dev/961
  • 087ql0af45.pages.dev/917
  • 087ql0af45.pages.dev/848
  • 087ql0af45.pages.dev/29

    • how does throttle by wire work